Design QAQC

Run QA against your drawing package

You’ve got a 60% electrical set for a 200 MW utility-scale solar job — one-lines, collection layouts, equipment schedules — plus the owner scope, Section 26 spec, and a third-party short-circuit study. Instead of flipping E-sheets for an afternoon, you tell the agent what to run: checklist pass, scope alignment, spec cross-check, study vs. one-line. It digs through the package, pulls excerpts from the scope and spec, and flags ratings or obligations that don’t match the drawings.

Download

Point the agent at your 60% set, owner scope, spec sections, and supporting studies. It walks the electrical package, runs your checklist, and cites sheet, spec, and study references for anything that doesn’t line up.

How it works

  1. Load the 60% drawing package, QA checklist, owner scope, spec PDFs, and studies (e.g. short-circuit) into the workspace.

  2. Tell the agent what to run — “60% electrical QA on E-100 through E-405” or “verify MV switchgear ratings against the short-circuit study and Section 26 36 00.”

  3. Iterate in chat — trace a finding to the one-line, spec paragraph, or study table; compare two sheets or schedules.

  4. Take the cited findings into your review log, markups, or issue tracker.

Download